After the phenominal success of the ATTx system released in 2004, the ATTx v2 was released in 2007.

The V2 system not only refines and improves on V1, it introduced a few new features.

The V2 ATTx system was developed and built to be forward compatible with future ATT products.

 

The V2 System, along with the ATTs Bite Alarm and the ATT Car Pager components, make up the ATT Modular System.

 

[Click image to enlarge]

ATTx V2 Features

 

  • Rubberised Finish - Receiver and transmitter covered in a protective non-reflective rubberised finish
  • Improved battery usage - The receiver is powered from a single 1.5 volt type “AA” battery. The transmitter is powered from a single 6 volt type "11A, A11, E11A, GP-11A, GP11A, L1016" battery
  • Mimics Alarm Beeps - The receiver will beep at the same rate as your alarm, from single bleeps to 'one-toners'
  • Receiver Low Battery Warning
  • User Selectable Tones - Receiver has 10 different user selectable tones
  • Activation on all LEDs - If you receive 2 or more simultaneous runs, the corresponding LEDs will be light up simultaneously
  • Last LED Activation Recall Function - check which was the last LED that was lit up
  • Improved Light Up time - LEDs remain lit up for 30 seconds
  • User settings retention - All user programmable settings are retained in the receivers memory even when the batteries are removed

 

Download the V2 Product Manual - includes the full list of features, programming instructions and usage tips.

 

 

NOTE : The V1 & V2 systems cannot be used interchangeably, i.e. V1 transmitters will ONLY work with V1 receivers & vice versa.